Skip to main content

Service

Gutter repair

Fixing a drainage system that is still fundamentally sound — as opposed to replacing one that has reached the end of its life.

Free on-site measure. A number quoted over the phone is a guess.

Dark gutter and downspout installed on a brick home

You probably want this if…

  • Water is dripping from a joint or a corner
  • A run has visibly sagged or is holding standing water
  • The gutter has pulled away from the fascia board
  • A downspout has separated or is blocked
  • Something came loose in a storm

The work

What actually happens

  1. 01

    Identify the actual failure

    Overflow, leaking and sagging look similar from the ground and have completely different causes. Overflow is usually a slope or capacity problem; leaking is usually a joint; sagging is usually hanger spacing or rotten fascia behind the gutter.

  2. 02

    Check what is behind it

    A gutter that has pulled away has often been pulling away because the board it is fixed to has gone soft. Repairing the gutter without addressing the fascia puts the same fastener back into the same wet wood.

  3. 03

    Repair or advise replacement honestly

    A single failed joint or a handful of hangers is a repair. A run that is undersized for the roof, or one where the same section has been resealed repeatedly, is usually money better spent on replacement — and that should be said plainly rather than discovered after three call-backs.

Planning the estimate

What shapes the price

Every home and scope is different. The final price depends on the measurements, material choices, access and the condition of the existing system. These are the factors Mountain Top reviews during the estimate.

Estimates are free. You receive a written specification and fixed quote before work begins; the price changes only if a genuinely hidden condition appears that could not have been seen beforehand.

  • How many separate failure points there are
  • Single-story or two-story access
  • Whether fascia repair is needed behind the gutter
  • Whether sections need to be re-hung or re-sloped
  • Downspout and outlet work

Around here specifically

What the desert does differently

The failure modes here skew toward heat, UV and grit rather than ice. Sealant at joints goes brittle faster under intense sun, wind-blown dust and gravel pack into low spots, and a season of monsoon overflow finds every weak fastener at once. Damage tends to appear suddenly after a storm even though it developed slowly.

Dark gutter and downspout installed on a brick home

Warranty on this work

Mountain Top labor

Three-year labor warranty on installed work

Gutter materials

Twenty-year material warranty on gutter materials

Full written coverage, exclusions, transferability and claim steps are confirmed with the quote. Manufacturer warranties are separate and vary by the exact product selected.

Questions

About gutter repair

My gutter overflows but does not leak. Is that a repair?
Often it is a slope or capacity problem rather than a fault. Re-sloping a run, adding an outlet or upsizing a downspout can solve it. If the gutter is simply too small for the roof above it, replacement is the honest answer.
Can one section be replaced instead of the whole run?
Sometimes — but a seamless run is one continuous piece, so a mid-run replacement introduces the joints the system was built to avoid. Whether that trade-off makes sense depends on the length involved.
How quickly can someone come out?
Availability changes with the schedule and weather. Call Mountain Top for the current response time and the next available estimate appointment.

Related work

Where we do it

El Paso, Texas and Las Cruces, New Mexico, plus the Mesilla Valley and border corridor between them.

Visit the coverage page for communities throughout the El Paso–Las Cruces borderland.

See coverage

Get a price for gutter repair

Start a free estimate